1. Remove all in planter light fixtures and save for the HOA.
2. Shut off the irrigation.
3. Cap off the irrigation.
4. Removal all existing landscaping and irrigation and dispose of.
5. Remove existing soil and dispose of.
6. Scrape off the existing waterproofing and dispose of.
7. Inspect the exposed surface for structural damage - report to HOA if found.
8. Inspect the existing drains for damage - report to HOA if found.
9. Apply Elasto-Poxy Primer VOC and allow to tack.
10. Apply the 1st coat of Elasto-Deck B.T. waterproofing at 45 mils.
11. Apply fiberglass mesh into the B.T and allow to cure over night.
12. Apply the 2nd coat of Elasto-Deck B.T. waterproofing at 45 mils and allow to cure over night.
13. Provide inspection from manufacturer to insure installation methods.
14. Allow materials to cure.
15. After the materials have cured perform a water test.
16. Drain the planters.
17. Install drainage mat.
18. Install termination bar.
19. Install PB4 protection board.
20. Import 12" of rock base, filter fabric and new soil to previous height.
21. Clean up.
22. Remove all debris from site.